In case of insufficient ST tendon thickness (less than 7 mm), then the gracilis tendon was also used [13].
If the static bed height is no more than 300 mm then the bed height has minimal effect on the fluidization characteristics.
Storage in ash and burned surface soil after wildfire was initially high (∼4 mm), then declined exponentially with time since fire.
Adsorption of Cr VI) on MLP increased with decreased particle size 1.4 0.5 mm, then decreased proportionately with further reduction in particle size reduced (Fig. 1).
The length of the ZnO NRs decreased, with the source molar content up to 20 mM, then increased up to 60 mM, and finally, saturated again.
Below 34 mm it was abruptly replaced by Fe2+, which reached a maximum of 870 μm at 37 mm, then disappeared by 51 mm.
The pH was 6.81 at the SWI, decreasing to a minimum of 6.20 at 20 mm, then recovering to 6.3 by 45 mm, the bottom of the profile.
The designs were applied on the Roger substrate material (RO3210) with dielectric constant of 10.2, substrate thickness of 1.27 mm, thickness of microstrip conductor of 0.035 mm, then simulated using the package Ansoft High Frequency Structure Simulator (HFSS).
The resulting paste was pressed at 10 MPa into nickel foam (ChangSha Lyrun New Material Co. Ltd., 90 PPI, 2 mm) then dried at 80 °C for 12 h.
Samples withdrawn from these tubes were centrifuged at 1400g for 10 min and the supernatant was filtered by syringe filter 0.45 mm then analysed to calculate the remaining dye concentration.
The pH was 6.59 at the SWI, decreased to a minimum of 6.51 at ca. 4 mm, then steadily underwent a marked increase with depth, to a final value of 6.87.
