Sentence examples for mm is constant from inspiring English sources
As the indenter diameter (5.2 mm) is constant, the only variables are the measured sample thickness and dynamic stiffness.
We performed synthesis experiments in which the initial concentration of sucrose (5 500 mM; 0.5 mM UDP) or UDP (0.005 1 mM; 100 mM sucrose) was varied while enzymatic activity (10 mU mL−1 OsCGT/ GmSuSy) and phloretin concentration (5 mM) were constant.
Their cross-sectional areas (Amean (m)) were calculated using the equation: Amean = π × [ a1 + a2 + a3 + a4 + a5) / 5] × [(b1 + b2 +b4 + b5 + b5) / 5] / 4. The length between P2 and D1 (L (mm)) was constant at 35 mm for all animals after completion of distraction.
Fractal dimension index of soil aggregates was calculated based on the size-number equation of Turcotte (1989) as follows: N_{i} = cX_{i}^{ - D} (3)where X i is the mean diameter of remaining aggregates on each sieve(mm) and c is constant coefficient.
One can see that core loss at large core diameters (D > 70 mm) is approximately constant regardless of the value of the tensile stress σ t applied during the pre-heating.
These results show that the critical size for increased resistance to rumen escape is larger than 1.18 mm and this critical size is constant throughout the day.
If the aqueous phase is of infinite volume, then the bulk concentration of Au+ is constant (c ∞ = 0.413 mM) and the equation may be integrated with the initial condition r(t = 0) = r0 to give the effective diffusion constant Deff.
All other process parameters such as target bias [900 V (ITO and ZnO) and −500 V (AZO)] and substrate distance (75 mm) were kept constant through the experiment.
Pump pressure at 350 MPa, abrasive type of Garnet and size of 120 Mesh, and nozzle diameter of 0.75 mm are kept constant throughout the experiments.
The operating temperature (30 70 °C), pressure (7 22 MPa) and effective nozzle diameter (500 1200 μm) were considered as the range of operating variables while spraying distance (1 cm) and nozzle length (5 mm) were held constant.
In present study, three variables, viz, deck eccentric, air flow rate and transverse angle were selected as operational parameters and the feed rate (90 kg/h) and longitudinal angle (78 mm) were kept constant throughout the experiments.
