Your English writing platform
Discover LudwigExact(7)
The ball slides at a stroke of 6 mm back and forth along extrusion direction.
The Ahmed Valve (New World Medical Inc, California, USA) was secured to the sclera in the superotemporal quadrant 8 10 mm back from the limbus.
In addition, the illumination beam is designed to fill the 3.0 mm back aperture of the 100x objective in order to achieve the best possible imaging resolution.
When stratifying the data according to body condition (≤ 14 mm back fat vs. > 14 mm back fat) and straw supply at farrowing (low vs. high), it turned out that 7 out of 9 thin sows had aceess to the large amount of straw at farrowing.
The 50x objective, on the other hand, has a 4.3 mm back aperture, and thus allows for a slightly larger percentage of the overall beam energy to pass through the lens.
Use pliers to make a little hook by bending the last half inch (10 mm) back until it makes an angle of about 30 degrees (a bit like a fish hook).
Similar(53)
The maximum load RMS voltage and power outputs of Configuration D were 105.4 mV and 1.35 mW at 6.29 Hz for load resistance 8.2 Ω and a base acceleration of 0.8 m s−2 with a 4.2 mm back-iron bar when the air gap between the magnets was 20 mm.
The armour module design composed of a SiC tile in confinement within 10 mm backing and 5 mm cover plates, which were made of AISI 4340 steel with varying hardnesses between HRC 30 to 50.
However, when performing radial imaging during pull-back (25 mm pull-back, 1000 images, ~25 µm spacing between images), only 504 radial A-scans per radial image were acquired, resulting in under-sampling of the tissue microstructure.
Aluminum (Al) top (1 × 1 mm) and back contacts were deposited using thermal evaporation (Figure 1f).
a Current responses to different pressures with compressive deformation from 0 to 12 mm and back to 0 mm.
Write better and faster with AI suggestions while staying true to your unique style.
Since I tried Ludwig back in 2017, I have been constantly using it in both editing and translation. Ever since, I suggest it to my translators at ProSciEditing.

Justyna Jupowicz-Kozak
CEO of Professional Science Editing for Scientists @ prosciediting.com