Sentence examples for ml feed from inspiring English sources

Five ml feed was mixed with 1 ml bedding, and water was added to a total volume of 15 ml with a 35 ml headspace of air.

The study intervention/placebo is given orally or via gastric tube once daily, unless the feed volume is less than 3 mL when one level ProPrems trial measuring spoon of powder is administered in 1.5 mL feed twice daily.

Following of above mentioned cultivation procedures, a feeding solution (FS) containing peptone and yeast extract as well as methanol and glycerol was added to the cultures batch-wise at a rate of 10 mL feed per 100 mL culture every 24 hours starting at 24 hours of fermentation.

The single-chamber membranless MEC with carbon anode and Ni-catalyst stainless steel cathode (liquid volume = 85 mL) fed with the ABR effluent with applied voltage = 0.6 V and electric conductivity = 7.45 mS/cm, achieved 99.0 ± 0.3% total COD removal efficiency, 1.31 ± 0.04 m3hydrogenydrogen production, 2.78 ± 0.11 mLhydrogen hyielden yield and 138.63 ± 3.11% electrical energy efficiency.

Macrophage-like cells and C. neoformans or beads were incubated together for 60 min to allow for completion of phagocytosis, washed once with fresh media, replenished with 2 ml feeding media and followed by time-lapse imaging every 4 minutes.

Gastric residual volumes are monitored every four hours and in the absence of a gastric residual volume above 200 ml, feeds are advanced to their target hourly rate by 25 ml/hr every four hours.

administered by two separate feedings (0.5 mL per feeding 4 hours apart using a standard mouse feeding needle (VWR, Radnor, PA).

To avoid the inhibitory effect of high glucose concentration on iturin A production, 0.3 mL glucose feeding medium was fed into 30 mL broth every 24 h (an average glucose feeding rate of 0.21 g/L/h) after initiating glucose supplementation, until the end of fermentation.

A 50 mL of feed solution (0.2 mM GA in acetonitrile) at room temperature (26 °C) was taken in five different flasks followed by addition of 500 mg of polymer beads (MIP1, MIP2, MIP3, MIP4 and NIP1).

Table 3 represents the electrical conductivity, salinity, and sodium-chloride ion concentration values in 100 ml of feed sample solutions for both RPSu-PVP and PSDVB-based IEM systems, respectively.

In this study, 500 mg of both MIPI1 and NIPN1 polymer beads were immersed in two different flasks containing 30 mL of feed solution (10 ppm of both GA and syringic acid).