Sentence examples for mixture indicates that from inspiring English sources

Discussion of the parameters of icy/rocky mixture indicates that the Rayleigh number is higher than critical value for onset of convection.

A comparison of a binary, single-sized biomass and glass particles mixture to a multicomponent mixture indicates that the binary system has similar mixing pattern as a multicomponent system.

Re-examination of the heteronuclear multiple quantum coherence (HMQC) NMR spectra of the enzyme inhibitor mixture indicates that dual modes of single covalent modification occur with a ≥3:1 ratio of S-alkylation of Cys172 to N-alkylation of His102.

Regardless of the number of hydroxylation events, the observation that one product is formed when RebC is added to a StaP reaction mixture indicates that accessibility of the active site of RebC must be tightly controlled, and our structural studies suggest that the "melting helix" is critical to that control.

At room temperature, the reaction proceeds slowly, however, after 12 h at 70 °C, the P NMR spectrum of the reaction mixture indicates that 3 has been fully converted to a new product, 4, which exhibits a second-order multiplet resonance at δ=−44.0 ppm (m, JP H=913 Hz, JP P=−30 Hz, JP H=1 Hz), which collapses to a singlet on proton decoupling.

Rheological study of sand foam mixture indicated that the yield stress increased with sand concentration.

Potential intermediates, 3 and 4, however, could not be detected by LC MS analysis in the NecC reaction mixture, indicating that nectrisine was the main molecule generated.

The release rate of 4-amino salicylic acid from its nanocomposite was obviously very much slower than that from the physical mixture, indicating that the nanocomposite potentially can be used as a better alternative as compared to the free drug.

The observed narrow monomodal molecular weight distribution resulting from the use of this mixture indicated that this diadduct did not react as a diinitiator but rather as a monoinitiator.

During an activation procedure consisting of repeated oxidation/reaction cycles at 773 K, the 810 cm−1 band disappears immediately after introducing a CH3OH/O2/H2O/He mixture, indicating that this surface atomic oxygen species participates in the reaction.

At the same curing temperature, the k t values determined at the start of the hardening phase were lower in the G50 and G65S5 mixtures than in the S5 mixture, indicating that k t decreases with an increase in the addition of GGBFS, as shown in Fig. 7.