Sentence examples for mixing of polypropylene from inspiring English sources

Particulate-reinforced polymer-ceramic composites were developed by high shear mixing of polypropylene (PP) polymer and tricalcium phosphate (TCP) ceramic.

Piezoresistive polymeric composites were prepared by melt mixing of polypropylene (PP) with expanded graphite (EG) (10 15 wt%) and/or multiwalled carbon nanotubes (MWCNTs) (1 2 wt%).

In this study, the morphology and rheological properties of nanocomposites prepared by melt mixing of isotactic polypropylene (i-PP), ethylene-propylene-diene terpolymer rubber (EPDM), and Cloisite 15A organoclay, were investigated at rest and under of uniaxial compression and stretching deformations at room temperature.

Researchers have proposed different methods including the use of polypropylene fibres in concrete mix designs in order to overcome these defects of HSC.

In recent years experimental investigations have demonstrated that the risk of spalling for a concrete material under fire conditions is drastically reduced by using a low dosage of polypropylene fibres in the mix design.

A compound containing 75 wt% of high-density polyethylene (HDPE) and 25 wt% of polypropylene (PP) was melt-mixed in an extruder.

This was interpreted as an improvement of freedom of urethane/urea groups and their mixing with polypropylene oxide.

It has been widely shown that the inclusion of polypropylene (PP) fibres in concrete mixes reduces the propensity for heat-induced concrete spalling, although considerable disagreement exists around the mechanisms behind the fibres' effectiveness.

One manufacturing method for the construction of fiber reinforced polymers is the long fiber reinforced thermoplastics (LFRP-D) process, where a matrix material, for example consisting of polypropylene and additives, is heated and mixed with fibers, for example carbon or glass fibers.

A mix with 10% silica fume, 30% perlite replacement ratios and 0.2% of polypropylene fiber satisfied the desired standards.

After six hours when most conidia had germinated, air was sparged into the culture broth, mixing was intensified (750 rpm) for more efficient oxygen transfer, and 0.01% (v/v) of polypropylene glycol (PPG) was added as an antifoaming agent.