Sentence examples for mixing is required from inspiring English sources

Dry mixing is required before the addition of water to ensure a homogeneous mix.

Design of fed-batch process configuration with sufficient mixing is required to improve process efficiency (Nguyen et al. 2015; Geddes et al. 2010; Unrean et al. 2015).

Hydrodynamic mixing is required to ensure frequent exposure of algae cells to light, to avoid the settling of algae cells, to homogenize the nutrient distribution and to enhance the utilization of CO2 in the pond.

For a continued chemical transformation of precursors at the interface of already formed perovskite CH3NH3PbI3−x Cl x and the existing PbCl2 film, where there is no van der Waals gap, a rather long and effective contact time and proper mixing is required [21, 25, 27, 41], which is not fully compatible with the regular sequential methods like spin/spin and spin/dip coating.

Measurements at a fixed location in a given reactor are useful in understanding changes in mixing that occur during the course of a given process, and are useful in manufacturing situations where validated documentation of lot-to-lot consistency of mixing is required (e.g. pharmaceutical manufacturing).

The results from our decay experiments confirm the importance of vertical mixing cited for UVC effectiveness in model rooms.[3], [10] Vertical mixing is required to move organisms from the lower room into the upper-room where UVC intensity is the highest.

For the cultivation of microorganisms, baffled shake flasks are employed when increased levels of oxygenation and mixing are required.

Thus, carbonized nanofibers with embedded MWCNTs may form a good basis for glucose FC anodes, but better metallization and cell-configuration allowing proper mixing are required.

Since the UHPFRC contained more constituents and finer particles than NSC and also included short and high-strength steel fibers, careful mixing was required to achieve proper workability, particle distribution, and packing density.

In addition, relative to Options 3/5, the use of a single hatchery facility with Options 2/4 would not require translocations between facilities when periodic mixing was required.

Powders with high purity were used to produce the oxidic implants (Tosoh ZrO2-20wt %Al2O3, (TZ-3Y20AB), as "ready to press" powders, so that no additional mixing was required before pressing.