Sentence examples for mixed interface from inspiring English sources

With the stability of the mixed interface, the multilayers also exhibited excellent thermal stability.

The width of atomic mixed interface between the coating and substrate formed by IBAD was approximate 3 μm, which was measured by Auger electron spectroscopy.

When there exists a gasoline and diesel mixed interface, in order to reduce the amount of mixed oil, the Reynolds number of the fluid in the pipeline must be larger than the critical Reynolds number.

Table 2 Allowable flow rate range of the pipeline segment between stations Pipeline segment Maximum flow rate, m3/h Minimum flow rate, m3/h (no gasoline and diesel mixed interface) Minimum flow rate, m3/h (a gasoline and diesel mixed interface) IS 1 OS 500 30 50 3 OS 4 OS 400 30 50 4 OS TS 400 30 50 500 30 50 3 OS 4 OS 400 30 50 4 OS TS 400 30 50

A mixed interface finite element is introduced to discretise the crack paths, the degrees of freedom of which consist in the displacement on both crack lips and the density of cohesive forces.

The numerical approach described here for structural shells uses Robin (mixed) interface conditions for the pressure and velocity in the fluid which are derived directly from the governing equations.

Depending on the I/A ratios, mixed interfaces of different widths, where silicon carbide exists, are formed.

We derive a spectrally accurate moving mesh method for mixed material interface problems modeled by Maxwell's or the classical wave equation.

The proposed model considers the batches' arriving time as time nodes and takes the influence of mixed oil interface on minimum flow rate into account, which increases the difficulty of calculation.

There is a mixed oil interface between 95# and 92# gasoline in the pipeline at the initial moment, at a location of 18.5 km away from the initial station.

Recent studies show also how the evaluation of mixed mode interface delamination phenomena, classical strength hypotheses along with fracture mechanics approaches and thermal fatigue estimation of solder joints can simultaneously be taken into account.