Sentence examples for minute values are from inspiring English sources

Since hourly values instead of minute values are used (i.e., accuracy of time lag is 1 h), the coupling efficiency might vary within a solar cycle.

The problems we have found in the hourly mean values (which are based on minute values) are very likely also present in data of higher temporal resolution, and once hourly mean values have been flagged as erroneous or data jumps and spikes have been identified it should be possible to correct the one-minute data.

CPM (counts per minute) values were obtained by scintillation counter.

One-minute values are used.

For this analysis, one-minute values are also used.

Two-minute values are shown in the graph.

In this case one-minute values are derived by applying a 7-point cosine filter.

One-minute values are derived at the data processing stage by applying a 61-point cosine filter.

For 12-min recordings, two 5-minute values were summarized for 3th-7th and 8th-12th minute intervals after excluding the first two minutes.

In that study, a strong correlation for ICP between the hourly mean values calculated from the 15-minute measurements and the end-hour value as recorded by the nurse (r2 = 0.95) was found, and perhaps more importantly, the frequency of perturbation in ICP detected by the 15-minute values was no different from that detected by the end-hour values.

However, after 60 minutes of LTD4 stimulation, a slight increase in heterodimerization (an average of 13 dots/cell) compared to the 5 minutes value was observed.