Sentence examples for minimum wear rate from inspiring English sources

Finally, optimal factor settings for minimum wear rate are determined using genetic algorithm.

In SBF, a minimum wear rate was observed for a process temperature near 400 °C.

The minimum wear rate is 1.895×10−5mm3/Nm for 0.5DG/PI, which was a 46.3% decrease from neat PI.

Finally, popular evolutionary approach known genetic algorithm (GA) is used to generalize the method of finding out optimal factor settings for minimum wear rate.

Signal to noise ratio analysis optimizes the parametric condition that yields minimum wear rate, minimum frictional force and minimum coefficient of friction.

The optimum process parameters for minimum wear rate were solution pH at 8.7, rotation speed at 61 rpm, solid percentage at 65% and crop load at 58%.

The minimum tool wear rate was obtained when the parameters are set at pulse on-time = 3 μs, pulse off-time = 3 μs, water pressure = 7 kg/cm2.

Optimized combinations of process parameters- voltage, duty factor and electrolyte concentration are obtained for responses- maximum Material Removal Rate (MRR), minimum Tool Wear Rate (TWR) and Radial Over Cut (ROC) are obtained using main effect plots.

Considering optimized condition offered by analysis of variance (ANOVA), maximum density (5.314 g/cmaximumximum hardness (786 HV), maximum compression strength (97.76 MPa) and minimum specific wear rate (0.0251 mm3/Nm) of FeNi Al2O3 nanocomposites were obtained.

Some previous studies have analyzed retrieved PUC buffers, measuring a minimum volumetric wear rate (1.4 14 mm/year), and a low number of wear debris particles without tissular reaction [ 66, 67], supporting previous in vivo studies [ 46].

Also, minimum vol. wear rate and frictional force for 0.5% Mn content ZA-27 alloy.