Sentence examples for minimum wall pressure from inspiring English sources

An increase in the maximum back flow velocity, a decrease in the minimum wall pressure and an upstream movement of the recirculation centre with increasing expansion ratio are also observed.

The length of the recirculation zone (LRE/H ∼ 7), maximum backflow velocity (UBMAX/UN ∼ 0.12), position of the recirculation centre [L PBMAX)/LRE ∼ 0.53] and position of the wall pressure minimum [L PWMIN /LRE ∼ 0.35] all remain approximately constant over a wide range of reactor geometries and operating conditions.

The flaws are local wall thinning, taking into account the minimum wall thickness required for design pressure and circumferentially part-through cracks based on the acceptance standards in the ASME Code Section XI.

In the next part for a predefined working pressure the minimum wall thickness of the vessel is calculated using two other design criteria i.e. (A) optimizing the hoop stress, and (B) assuming a suitable percent for the penetration of yielding within the wall thickness.

The primary issue in pipe design is the minimum wall thickness for pipe sizes when exposed to given temperatures and pressures.

As depth increases, the wall pressure increases for all cases.

Pressure transducers recorded the initial pressure wave and the cavity collapsing pressure and related these to the back wall pressure.

In such a plot, pressure represents the sum of the transpulmonary pressure gradient and the chest wall pressure gradient.

Then move it down about 1mm (which is the minimum wall thickness for a 3D printer.

Minimum pressure was the lowest pressure observed during the filling phase of the CMG, and peak pressure was the maximum pressure observed during the CMG.

Table 10 Pressures at maximum and minimum of Permeability Pressure at maximum permeability (Pa) Pressure at minimum permeability (Pa) Sample 100 5 D1000 100 100D1000.