Sentence examples for minimum thickness for from inspiring English sources

To ensure a minimum thickness for each member, a geometry sizing constraint is imposed via piece-wise bounding polynomials.

It is inferred from the results that there is a minimum thickness for the mat which yields lesser strength CV%.

In our previous research, to produce a high capacitance density, BaTiO3 was deposited on Cu substrates by the AD process at room temperature, and the film thickness was reduced to confirm the critical minimum thickness for dielectric properties.

BaTiO3 films were fabricated on Cu substrates by the AD process at room temperature, and the film thickness was reduced to confirm the limit of the critical minimum thickness for dielectric properties.

Finally, the Si-cap thickness should be controlled precisely to locate the buried channel as close as possible to the oxide as long as the minimum thickness for a low Dit is maintained.

CharacTheization with an AFminimum Nanoscrathicknessesnique suggests a more than two times increased resistivity against plastic deformation fullHcoverage cofpared themediatron sputtered CNx overcoats.

From these experimental results, an analytical model based on classical Westergaard well known equations has been developed to calculate the minimum thickness of RRFC for rigid pavements subjected to high density traffic, in order to obtain a durability of these rigid pavements of 106 cycles of 13 tons (127 kN) axle load.

Our work provides direct evidence of the mechanical robustness of thick carbon coating and offers a minimum thickness of carbon coating for constraining the deformation of anode materials with large lithiation-induced volume change.

Results of the experimental programs are briefly discussed, and design expressions for evaluating the minimum thickness of FRP jacket required for seismic bond strengthening are presented and compared.

Ikawa et al. [3] investigated the minimum thickness of cut (MTC) for ultrahigh machining accuracy.

Optimal computation or light-weight design was carried out for minimum thickness of the tubesheet with the precondition of strength requirements conforming to the design-by-analysis code JB4732-1995.