Sentence examples for minimum thickness and from inspiring English sources

Hence, achieving the proper experimental condition which leads to the growth of a layer with minimum thickness and desirable properties as well as reasonable production cost and overcome the tellurium insufficiency is required.

On radiographs acquired 6 weeks after arthroplasty, the mean error was −0.1 mm (underestimate) ± 0.6 mm (standard deviation), with 72% of the measurements within 0.5 mm of the original minimum thickness and 87% within 1.0 mm.

One of the major findings of this case study is that incremental increases in performance requirements can drive step change increases in manufacturing cost due to discontinuities in the material and process trade space, i.e. using titanium versus aluminum to meet temperature requirements or having to use investment versus sand castings to meet minimum thickness and tolerance requirements.

The output performances of the FH-TENGs with different layers, areas, minimum thicknesses and radii of the flexure hinges substrate are also systematically studied and discussed.

These measurements were compared with the actual minimum thickness values and locations of the retrieved tibial inserts after revision.

Moreover, the thickness of the fabricated oxide layer was almost constant: the maximum and the minimum thickness were 10.6 and 9.22 μm, respectively.

The material used defines the minimum section thickness and minimum draft required for a casting as outlined in the table below.

Eurocode 2 provides a chart of minimum thickness of walls and cover based on the required fire resistance rating, which is determined by the number of exposure surface and loading condition.

The relationship between the intercept for the minimum thickness, B min, and the intercept for the remaining thicknesses D = (d 1, d 2, d 3) was found to be linear and dependent on the difference between the minimum and remaining thickness.

Pennsylvania requires that pit liners for temporary impoundments and disposal have a minimum thickness of 30 mil and that seams be sealed to prevent leakage.

The maximum thickness was fixed at 800 μm (global thickness) and the minimum thickness was modified from 250 to 500 μm.