Sentence examples for minimum strength of from inspiring English sources
In cementing operation, certain minimum strength of about 500 psi is required before restarting the drilling operations (Backe et al. 2001).
Through the input interface in this model, users are also allowed to input safety factors, which are used to quantify the minimum strength of all casings.
One specific concrete mixture which fulfils the requirement for minimum strength of LC 20/22 is used for the test series.
By utilizing estimations of UCS derived from the correlation of porosity, the minimum strength of the rocks can be applied to important engineering issues such as wellbore stability (Chang et al. [2006]; Schöpfer et al. [2009]).
In this paper, the minimum strength of SiC components was calculated by Monte Carlo simulation, and the minimum strength evaluation method of SiC components was developed by using the results of simulation.
The minimum strength of interaction was established by competition studies using soluble synthetic peptide analogs, which showed half-maximal inhibition of yeast binding to CdS at ∼2 μM peptide.
The minimum strengths of the FDI attacks that were successfully detected without triggering any false positive detections (see in Table 3) expectedly increased with the increase of forecast MAPE.
The geopolymer composite of 15 wt% carbon micro fiber was found to maintain the residual compressive strengths of 33.55 and 23.96 MPa at 400 °C and 800 °C, respectively and thus recording a minimum strength loss of 19 and 42%, respectively.
The geopolymer composite of 10 wt% basalt microfibrils maintained the residual compressive strengths of 23.13 and 16.08 MPa at 400 °C and 800 °C, respectively and thus recording a minimum strength loss of 32 and 43%, respectively.
Since accurate strength estimation of individual ceramics structure is difficult, a prediction method of minimum strength in the structure of the same design was proposed based on effective volume theory and optimized Weibull modulus.
Also, the minimum strength (about 6.94%% of the base material) occurred in a sample welded with rotational speed of 780 rpm and traverse speed of 62 mm/min.
