Sentence examples for minimum signal level from inspiring English sources

Ultimately, the minimum signal level detectable at the output of an amplifier or radio receiver is that level which appears just above the noise floor level.

A minimum signal level just below threshold was set for each tissue section; this was based on an average background reading from regions without staining.

To do so, we needed to define a minimum signal level and also when two adjacent positive probes could be considered part of the same binding region.

To minimize noise from tissue auto-fluorescence a minimum signal level just below threshold for detection of doxorubicin was set for each tissue section; this was based on an average background reading from regions without nuclear fluorescence/staining.

As 5X coverage represents a minimum signal level needed to reliably differentiate a methylated locus from a locus with no methylation (or the absence of a methylation signal), we speculate that this increase could significantly increase the statistical power to detect DMRs, particularly in small or lightly methylated regions.

The statistics throughout the 2.4 GHz ISM band, i.e., the mean, median, maximum and minimum signal levels.

Comparison of the Tukey mean maximum and minimum signal levels for all probe-sets corresponding to nuclear genes revealed 122 genes that showed a greater than 10-fold change between two or more of the five biological conditions tested.

Because the received SINR at the secondary receiver should be greater than the minimum signal decodable level γ S on each channel j, the minimum transmission power P i, j Min of ST i on channel j can be obtained from (17).

We define the five-sigma value (55 K) as the minimum detectable signal level.

LFN determines the minimum value of signal level in electronic devices and circuits, affecting the realization of scaling down and lower power consumption in future circuits [65, 66], showing that it is necessary to study the LFN in MoS2-based FETs as this 2D layered material has been widely utilized for the fabrication of ultrascaled FET [67] and integrated circuits [68].

where FAPi RSSI i ) represents that i th neighbor FAP from which the received RSSI level at the MS is greater than or equal to ST 0. ST 0 is the minimum level of the received signal from an FAP that can be detected by an MS. The number of FAPs listed based only on the minimum level of received signal level, ST 0, can be calculated as follows N = … FAP # i RSS I i, … : 1 ≤ i, RSS I i ≥ S T 0. (2).