Sentence examples for minimum reinforcement requirement from inspiring English sources

This minimum reinforcement requirement is also enforced for slab top bars because the negative bending moment may be developed over the entire slab at high temperatures.

The design of slab top and bottom reinforcement at the middle strips is governed by the code minimum reinforcement requirements to control cracking due to shrinkage and normal temperature changes.

Their seismic design is often conditioned by the need of reducing their flexibility by increasing the cross-section of the columns, which, due to minimum reinforcement requirements, results in their over-strengthening.

The capacity of the diagonal strut can be estimated from ( v_{cv1} ; = ;0.85 beta_{s} f_{c}^{{prime }} ), where β s = 0.6 as suggested by the ACI 318-11(American Concrete Institute 2011) for bottle-shaped strut with web reinforcements not satisfying the minimum reinforcement requirements, while the capacity of the horizontal strut is taken as ( v_{cv2} ; = ;0.85 f_{c}^{{prime }} ).   6.

Table 5 presents the minimum shear reinforcement requirements as well as the maximum spacing limitations for shear reinforcement of the aforementioned standards.

Test results indicate that the minimum reinforcement ratio (0.7%) recommended by the Canadian Highway Bridge Design Code 2006 CHBDCC 2006) for bridge deck slabs reinforced with GFRP bars satisfied the serviceability requirements after being subjected to the simulated cyclic exposures.

Twelve beams (three for each concrete type and strength) were designed to preclude flexural and shear failures and satisfy the minimum and maximum longitudinal reinforcement requirements of ACI 318-08 (American Concrete Institute ACI Committee 2008).

Eight beams (six without shear reinforcing and two with shear reinforcing in the form of stirrups) with three different longitudinal reinforcement ratios for each concrete type were designed to preclude flexural failure and satisfy the minimum and maximum longitudinal reinforcement requirements of ACI 318-11.

The length of the bolts and their spacing can be varied, depending on the reinforcement requirements.

Also out was language saying the military must be able to swiftly defeat an enemy with minimum reinforcements.

Paultre and Légeron (2008) showed different code limitations in confinement reinforcement requirements.