Sentence examples for minimum received power from inspiring English sources

In the context of the coexistence of WiMAX with MB-UWB OFDM, determining the maximum permissible interference level that maintains a satisfactory quality of service of the victim receiver, even in situations of minimum received power, is indispensable.

The minimum received power values have been derived based on the receiver sensitivity requirements specified in IEEE802.11a standard [26] and the SINR values recommended in [20] for a bit error rate (BER) of 1e −5 or less.

where is the minimum received power, the directivity of the transmitter antenna, and the effective receiver area [13].

Therefore, we choose the interference threshold to be 6 dB below the thermal noise level, in order not to introduce significant performance loss in case the primary receiver is operating close to the sensitivity level (i.e., minimum received power level expected to be detectable).

The minimum received power is calculated in the OMNeT++ simulation module named Connection Manager [13].

This value corresponds to the the minimum received power for cellular coverage and is equivalent to a spectrum efficiency, that is, (obtained via Shannon law).

The minimum required received power used was −45 dBm (31.6 nW) for all network nodes.

Here, the coverage is defined as the maximum coverage range, which satisfies the UE's minimum required received power P min. The effect of shadowing will be averaged out for the network planning of the CP construction and adaptation.

As we will show later in the simulation results, without transmission power constraints, there are some power values for a given distance between a source and a destination where the communication cannot be completed with respect to a minimum threshold received power.

The multipath power sensitivity S M, expressed in decibel-milliwatts (dBm), is the minimum required received power at the PHY layer of a given TM which guaranties the QoS settled by a maximum BLER or bit error rate (BER) on data transmission.

The affected area is defined as the area where a minimum received signal power (P min ) is observed.