Sentence examples for minimum mass flow from inspiring English sources

A minimum Mass Flow Parameter Standard Deviation of ±0.091 kg/s K0.5 bar is found at 1206 rpm/K0.5.

The minimum flow rate required to maintain a film is known as the minimum wetting rate which is defined as the minimum mass flow rate per unit circumference.

Comparing these three fluids, toluene presents the highest efficiency, the highest impact on the environment, the biggest vapor specific volume, and the minimum mass flow rate in Rankine cycle, therefore decreasing the pump power consumption.

In case of rolling mill reheating furnace, a design for the minimum mass flow rate and bypass of any exceeding fluctuation appeared the most economical solution, whereas the best environmental performance was achieved for lower bypass of the heat source.

The computational fluid dynamics (CFD) analysis is performed to obtain the minimum mass flow rate of the coolant which is necessary to keep the structure's temperature below the permissible limit at an acceptable pressure loss.

First, a set of steady state simulation was carried out for a band of inlet mass flow rates, which gives the minimum mass flow rate required for removing the maximum heat load, by virtue of prediction of hot spots inside the Calandria.

The case with the largest longitudinal wind velocity will gain the minimum total mass flow rate of smoke exhausted in spite of the shaft amount, due to the fact that a very obvious boundary layer separation occurs in the shaft.

The design is based on a separation of the current carrying part and the heat exchanger part as well as the presence of the so-called superconductor inserts made of Nb3Sn wires inside the conductor in the heat exchanger area which allows the operation of the current lead at minimum helium mass flow in a wide current range.

A model is developed based on system mass and energy balances coupled with kinetic equations to ascertain mixture conditions at each state point in the loop, as well as mass flow rate, minimum work input, and minimum endothermic reactor volume according to defined reservoir temperatures and desired heat load.

The minimum possible diameter depends on mass flow rate (capacity) and division of flow path.

Jenike's shear cell technique was applied to evaluate the wall friction, in particular, the wall yield locus and angle of wall friction, and to evaluate the minimum hopper angle required for mass flow.