Sentence examples for minimum fragment size from inspiring English sources

As we have already mentioned in the previous sections, the GSC can allocate the shared spectrum among the operators based on fragmentation depending on the operators' desired minimum fragment size and channel quality information.

The power law distribution requires the presence of a non-zero minimum fragment size rather than a continuous distribution that includes particles approaching zero size.

From that, the operator calculates the required guardband, and considering the guardband size, the operator then claims a minimum fragment size.

Based on a high-performance liquid chromatographic pump, we have built a device that allows recirculation of DNA through a 63-microm orifice with ensuing fractionation to a minimum fragment size of approximately 300 base pairs.

Each operator can claim a minimum fragment size to limit the overall guardband overhead given as (frac {B_{text {guard}}}{B_{text {frag}}}), where B guard is the total amount of spectrum belonging to all the guardbands and B frag is the total amount of frequency spectrum belonging to all usable fragments.

We found that mean intensity degrades as minimum fragment size increases above the maximum optimal size of 1 kb, and differs by more than one standard deviation from the mean of probe sets within the optimal size range when minimum fragment size increases above 1500 bp.

The results were filtered on the basis of following criteria: (i) minimum and maximum fragment size obtained on agarose gel: 100 bp and 2,000 bp, respectively (ii) minimum number of repeat units: 4.5.

Minimum length was determined as 150 bp, approximating the minimal chromatin fragment size used in a library procedure.

When the throat contained two equal angles of 45°, most powder deposition occurred at the first angle, indicating that the first angle was likely to cause major de-agglomeration, while the second angle might act as a facilitator for further break-up, but the deposition was minimum as the fragment sizes and velocity at the second impaction were smaller.

The mean coverage obtained by mapping read pairs with the correct fragment size was 82.9× and we used a minimum coverage of 20-fold to call changes (see Section 2).

ChIP-seq reads were mapped using BWA [ 84] and peaks detected using CCAT 3.0 (Settings: fragment size = 200, sliding window size = 500, minimum score = 3.0) [ 85].