Sentence examples for minimum contact force from inspiring English sources

The maximum and minimum contact force is the actual maximum contact force and the minimum contact force exists between the pantograph and catenary when the vehicle passes the evaluation section.

Liu (1999) solved the buckling differential equation with the Galerkin method and derived the critical helical buckling loads in build and drop-off wellbore sections by letting the minimum contact force on the tubular string be 0. Liu's results indicate that the up-limit value of the sinusoidal buckling is rather close to the critical helical buckling load.

Therefore, according to evaluation index system in this study, the maximum contact force between the pantograph and catenary should be less than 79 N, the minimum contact force between the pantograph and catenary should be greater than 44 N, and the optimum mean contact force should also be in the range of 59−10+1010  N [2].

The results of these impact and post-impact tests showed that the maximum contact force was observed in the [R]8 fabric and the minimum contact force was observed in the [P]8 fabric and the CAI strength reduced by increasing the impact energy.

For each application, the precise location of the catheter was registered and the following data were extracted from the Tacisys® unit: application duration, minimum contact force, maximum contact force, average contact force (CF), and force time integral (FTI).

The CFF is to determine if there exist feasible contact forces to maintain a robot in equilibrium without breaking its contacts with the environment, while the CFD is to compute the minimum contact forces if a feasible solution exists.

Visual inspection, in addition to a post-hoc sensitivity analysis of contact area and contact force, confirmed this minimum threshold successfully excluded soft tissue contact with the thin-film pressure sensor.

We used an optimization algorithm to identify a fragment orientation that results in the minimum contact pressure (while holding the joint center and joint force constant).

Additionally, the proposed control scheme guarantees the satisfaction of certain pre-defined bounds regarding the maximum overshoot, the minimum convergence rate and the maximum steady-state error for the contact force, the position, and the orientation tracking errors.

We monitor the force between the two surfaces, the total potential energy, the Q6 order parameter, the effective minimum contact radius and the conductance (using the modified Sharvin equation).

Contact force (N).