Sentence examples for minimum axial span from inspiring English sources
For measurements in reflective ducts, the sound pressure spectrum is to be averaged over a space diagonal in the rectangular duct with a minimum axial span of one-quarter wavelength at the lowest frequency of interest, and the modal correction for the above-described measurement path is to be applied.
It appears that minimum axial rigidity is a better model for measuring bone rigidity than average axial rigidity.
As shown, minimum axial rigidity appears to be a better model for measuring bone rigidity than average axial rigidity.
The CTRA based average and minimum axial rigidities were compared to average and minimum axial rigidity values obtained from mechanical testing.
The CTRA-based average and minimum axial rigidities were correlated with the mechanical testing based -average and minimum axial rigidities using a paired t-test analysis (p = 0.37 and 0.18).
Results in Figs. 7 e) and 7(f) show maximum axial force and minimum lateral force with φ = 0; as well as minimum axial force and maximum lateral force with φ = π/2.
The CTRA average and minimum axial rigidities were correlated with the mechanically-derived average and minimum axial rigidities using paired t-test analysis (p = 0.37 and p = 0.18, respectively).
This correlation improved significantly (p < 0.0001) when the CT-based Structural Rigidity Analysis (CTRA) minimum axial rigidity was correlated to the mechanically-derived minimum axial rigidity results (R = 0.84).
The majority of nodes were >10 mm in minimum axial diameter although the trend appeared to extend to smaller nodes.
Minimum axial rigidity produced a stronger correlation with mechanical testing based minimum rigidity results (R = 0.84) than their average counterparts (R = 0.74).
Consequently, the minimum detectable axial velocity (V axial,min) is given by The range from the minimum to the maximum detectable velocities, as defined above, determines the axial Velocity Dynamic Range (VDR) of each PR-DOCT system.
