Sentence examples for minimizing the surface from inspiring English sources
Optimum machining condition for maximizing metal removal rate and minimizing the surface roughness is determined using desirability function approach.
Nanofluids fluids seeded with nanoparticles as another alternative have been studied5,6,7 as volumetric absorbers, potentially minimizing the surface energy loss by uniform temperature in the fluid6 and enhanced thermal conductivity of nanofluid8,9.
The effect of cutting parameters on surface roughness was evaluated and the optimum cutting conditions for minimizing the surface roughness were determined.
The optimization results revealed that burnishing feed and burnishing speed are the significant parameters for minimizing the surface roughness, whereas burnishing force and number of passes play important roles in maximizing the hardness.
The optimum parameter set in maximizing the material removal rate and minimizing the surface roughness is standoff distance – 4.22 mm, transverse speed – 223.28 mm/min, and percentage WC – 2.10%.
The optimization study is performed with the aim to fulfill the design requirements of the heater, i.e. the provided mass flow rate and the outlet water temperature, while minimizing the surface area of the coil characterizing the Puffer and thus reducing the overall cost of the device.
We tried to minimize the surface area of the solenoid shaft by attaching a dull blade at the tip but it still did not work properly.
These outcomes have prompted variations in mesh design to minimize the surface area interface and increase integration with host tissue.
To maximize the penetration depth and minimize the surface roughness, the range analysis and subsequently overall balance method were adopted to identify the most significant factor and level.
The high-k dielectric layer of Al2O3 acts as an electron blocking layer which minimizes the surface recombination at the interface.
Surface Evolver software was used to minimize the surface energy and introduce the typical architectural characteristics of the open cell foam to the FE-model.
