Sentence examples for minimizing the joint from inspiring English sources
However, for non-stationary signals, maximizing the MI gives more stable and consistent estimate of the relative delay than minimizing the joint entropy.
In [10], the Laplacian is employed to model the speech source, and the relative delay is estimated via minimizing the joint entropy of the multiple microphone output signals.
It is revealed that, maximizing the MI for TDE gives more consistent results compared to minimizing the joint entropy since it is insensitive to the variance change of sensor outputs.
The procedure to obtain an experimental design suitable for this task works by simultaneously minimizing the joint confidence region for the coefficient estimates and the correlation among them and with the block.
Since the two information-theoretic measures have the freedom of selecting a specific distribution model for the source signal, the solutions based on minimizing the joint entropy and maximizing the MI of the multichannel output signals are derived for both Gaussian and Laplacian models.
Minimizing the joint free energy between two RNA molecules under a number of energy models with growing complexity was introduced in [ 2].
The objective is to minimize the joint annual cost incurred in the supply chain.
It is demonstrated that the predicted results of the optimization are in good agreement with the experimental results, so this study provides an effective instruction to enhance the joint quality and minimize the joint cost.
The aim of this article is to minimize the joint transmit power for both CTPs, while satisfying at the same time the system throughput requirement R S as well as the individual transmit power constraint per CTP.
The ultimate goal of the power allocation scheme is to minimize the joint power consumption of the system, but verifying at the same time the target throughput and the individual power constraint per CTP.
We hypothesize that adjustments concerning crank position could minimize the joint range of upper extremity motions and/or avoid reaching the joint limit, which are considered as risk factors for repetitive strain injuries (RS I.
