Sentence examples for minimize the increase from inspiring English sources

She needed to get the existing processes cleaned up and AR days as efficient as possible to minimize the increase that she knew was coming.

The objective of calibration is to minimize the increase of construction costs, compared to the non-simplified safety format, without reducing the level of structural safety.

Some riders might be "tipping less to minimize the increase in overall cost since the fare increase," said Michael Lynn, a Cornell University professor of consumer behavior and marketing, while others might be proponents of a flat tip not tethered to the amount on the meter.

The aim, therefore, for achieving the optimization of heat exchangers must be always to increase the heat transfer, and simultaneously minimize the increase in the pressure drop [1].

Although the setting reaction of Ca P cement is also exothermic, the compositional modifications can minimize the increase in temperature, keeping it in a relatively safer zone to biological cells.

Since the dendrogram chooses clustering steps that minimize the increase in the error sum of squares at each level, the formation of distinguishable clusters that differ between cetaceans and mice illustrates that the aminogram patterns differ remarkably between these two groups.

Perhaps colleges and high schools can work together to devise ways to minimize the increased workload.

In order to minimize the increased risk of adverse outcome in diabetic pregnancies, careful preparation before pregnancy and medical care throughout pregnancy should aim to achieve optimal glycemic control [ 4].

There would also have been selection on rRNA to reduce the error rate of the ribosome at the same time as the code was evolving, and this may have helped to minimize the increasing number of errors that would be inevitable as the number of amino acids in the code increased and the codon blocks got smaller.

The bonding layer is applied on the surface of a SPAES membrane using a spraying technique to achieve an extremely thin layer (700-nm thick) that minimizes the increase in the MEA resistance.

Minimizing the increase in ESR posed the greatest design challenge, which limited realistic operation of these test cells to −55 °C (still improved relative to the typical rated limit of −40 °C for commercially available non-aqueous cells).