Sentence examples for minimize the absorption from inspiring English sources

The PBS degradation was thought to minimize the absorption of excess excitation energy under stressful conditions [ 44].

The advantageous part is that these materials exhibit larger bandgap than CdS, thus minimizes the absorption loss between the wavelength regions of 350 550 nm.

Placing PN electrodes on the same side minimized the absorption caused by electrodes in conventional vertical injection light-emitting diodes (V-LEDs) and the current spreading was improved.

Sulfasalazine and formulations of 5-ASA (pH-dependent and controlled release formulations) were developed to minimize the systemic absorption and maximize the delivery of the mesalamine to colon.

In order to minimize the parasitic absorption at the rear side of structure E, a SiO2 layer (1 μm) was used to separate the rear INP and Ag layer, as demonstrated by structure F in Fig. 4c.

To minimize the water absorption and to improve the thermal insulated properties of the insulation materials used for the cargo containment systems (CCSs) of LNG carrier, a kind of expanded water-repellent perlite has been developed by coating hydrophobic membrane onto the outer surface of the expanded perlite to change its physical and chemical characteristics.

Using 295 nm as the pump wavelength can minimize the tyrosine absorption in pol β.

It is preferred to detect flame emissions at longer wavelengths in the visible spectrum to minimize the self-absorption effect.

The 2013 edition of the American Association of Gynecological Laparascopists Practice Guidelines advise the choice of a distension medium that is the least likely to cause complications in the event of excessive absorption; minimizing the systemic absorption of the distension medium during surgery; and early recognition of excessive absorption [ 7].

In order to minimize the free carrier absorption loss in the n-doped (S, 2 × 1017 cm−3) InP substrate and improve the material quality, a 3-μm-thick low-doped (Si, 2 × 1016 cm−3) InP layer was first grown on the substrate by metal organic vapor phase epitaxy (MOVPE).

To minimize the variability in absorption, abiraterone is labeled for administration as 1,000 mg (four 250 mg tablets) daily on an empty stomach, defined as 1 hour before or 2 hours after a meal.