Sentence examples for mine table from inspiring English sources
Mineral matter (11.6 vol%, mean of all the seams) occurs in moderate concentration in all the seams at Giral mine (Table 2a, b).
Soils at Goonyella mine (Table 3) varied in a range of chemical properties in comparison to rehabilitated sites and reference areas.
Similar significant differences between pH, EC, and total phosphorus at Oaky Creek mine (Table 3) suggest that there are consistent differences between replaced soils and those found at selected reference sites.
Soil collected from the three sites most proximal to the Mariscal mine (Table 1, MSC1, MSE6, and MSW11) contained some fine-grained mine waste calcine, which was likely windblown from calcine piles found in this mined area.
As an evolution to this approach, a dynamic clinical "data mining" (Table 1) has been recently proposed, based on "data-driven" methods (Additional file 1: Figure S1).
Factor 4 and factor 5 may direct the anthropogenic effects due to fertilizer uses in the agricultural purposes and one the most important use should be noted in the mining area is the use of ANFO (Ammonium Nitrate Fuel Oil Mixtures) in order to secondary blasting and hence breaking down of the hard rock in the area to be mined (Table 9).
As a result, 1262 putative SNPs, including 37 putative indels were mined (Table 1).
It is therefore necessary to conduct comprehensive, detailed studies on all relevant subgroups for an accurate picture of the entire burden caused by mercury exposure from gold mining (Table 8).
On the 9 new mRNA data sets each for one miRNA rule, many 100%-frequency rules were mined by our proposed rule mining method (Table 2).
The results of both generating new test sequences across land plants (Table 4) and in data mining GenBank (Table 3) demonstrate the utility of this approach.
However, the average of the mine-specific values is not as reliable as the value obtained modeling a single slope for all mines (0.39 0.43) (Table 2), because the single slope adjusts for differences in the data from the different mines, such as the number of samples, whereas the average of mine-specific slopes does not.
