Sentence examples for min which resulted from inspiring English sources

Further, the solution was heated to 250 °C for 30 min which resulted in black colored solution of FePt.

However, the linear growth broke down when the growth duration lasted for 120 min, which resulted a height of 4.6 mm.

The optimum conditions found were applied current of 354.3 mA, GAC dosage of 47.1 g/L, initial pH of 5.4, and reaction time of 55 min which resulted in 98.56 ± 0.14% of COD removal efficiency.

The optimum operational conditions were 47.1 °C, 0.16 mol L−1 H202, 20 g L−1 of catalyst and 92 min which resulted in the maximum removal efficiency (98.5%).

It was found that the application of 80% strain to fibrin hydrogels for 30 min (which resulted in a permanent strain of 47.4%) produced a 2.1-fold increase in the subsequent compressive modulus.

In both cases, the delay between the start of the CTM and SS measurements was 17 min, which resulted in an overall decreased activity of 10%% during the course of the two scans due to the physical decay of 18F.

Compared with conversional heat treatment (i.e., 550 °C for 4 h), the MIAS method provides rapid heating of the Ni/VMT precursor (i.e., 700 W for 4 min), which results in a Ni/VMT catalyst with highly dispersed active sites.

After the alumina layer was removed in a mixture of phosphoric acid (6% wt) and chromic acid (1.8% wt), the Al sheet was again anodized under identical conditions to those of the first anodization for 30 min, which results in forming porous alumina film on the aluminum surface.

Prolonged CIT was defined as the mean CIT (622 min) plus the standard deviation (239 min) which results in a CIT > 861 min (the CIT was normally distributed, Kolmogorov-Smirnov-Test: p < 0.001).

Cell-dehydrated rats treated with baclofen (0.5 nmol/0.2 μl) into the LPBN ingested 17.9 ± 4.2 ml of 0.3 M NaCl and 5.2 ± 1.9 ml of water in 210 min, which results in a hypertonic solution (nearly 0.23 M).

However, fluid replete rats that received baclofen into the LPBN ingested 14.3 ± 4.1 ml of 0.3 M NaCl and 7.1 ± 2.9 ml of water in 210 min, which results in a hypertonic solution (0.2 M).