Sentence examples for min were kept from inspiring English sources

Dwell time of 1 μs and sputter time of 5 min were kept constant.

During this stage, the solutions' pH (5.5), biosorbent mass (0.4 g), stirring speed (200 rpm), and contact time between biosorbent and solution (60 min) were kept constant.

Only analytes for which both ions were found with a retention time difference within 0.05 min were kept.

For each temperature, a period of 5 7 min was kept until increasing the temperature.

The value of R min was kept zero; that of R max was selected for each individual data set by successive runs with different values of this parameter to obtain the minimal discrepancy between the experimental and calculated scattering curves.

For a single temperature increase adjustment, only 5 7 min are kept, so the biofilm does not have enough time to grow and the result represent the effect of temperature on the same biofilm.

Two separate experiments were performed where either the total number of cycles (3600 cycles) or the total loading time (60 min) was kept constant.

For this purpose, 10 mL of graphene oxide was added to 20 mg of PEG and then sonicated for 10 min. After being sonicated for 5 min, samples were kept on an oil bath at approximately 80 90 °C, under a hood.

All slices used in optical recording were stained with a voltage-sensitive dye (RH155 0.2 mg/ml, Nippon Kanko Shikiso Kenkyujo, Okayama, Japan) for 15 min, and were kept in a chamber containing oxygenated ACSF for at least 30 min for recovery as described previously.

After washing with PBS (4x10 min, samples were kept at 4 °C in the dark.

After 10 min cells were kept on ice and suspended in ice cold PBS.