Sentence examples for min was attributed from inspiring English sources

A maximum latency of 2 min was attributed for each animal that did not fall during the test.

The peak with a retention time of 25.57 min was attributed to phenanthrene-9,10-quinone but was barely detectable at 24 h and had a much lower intensity than the peak at 0 h, suggesting that phenanthrene-9,10-quinone is rapidly metabolized by HepG2 cells over this time course.

To the extent that decreasing CV of EC fluxes reflects reduction in micrometeorological sampling errors, half of the observed variability at τp=30 min is attributed to sampling errors.

In this context, initial steep-sloped portion (from 0 to 60 min) is attributed to the external surface adsorption or instantaneous adsorption, while gentle-sloped portion (from 60 to 240 min) is associated with the gradual adsorption.

As the species with higher molecular weights are eluted in shorter retention times, the HPLC peaks observed at retention time 9.65 min were attributed to free CC49 (Figure 6A,B).

Similarly, ions of m/z 301 (at 12.8 min and 25.5 min) were attributed to dihydrokaempferide and E/Z communic acid, respectively.

Based on the retention times of the standards, the signals obtained at 4.5, 7.0, 8.5, 9.0 and 11.5 min were attributed to 1-kestose, 6-kestose (β-D-fructofuranosyl(2→6 -β-D-fructofuranosyl-(2→6 -β-D-fructofuranosyl-, neokestose (β-D-Fructofuranosyl-(1→6)-β-D-fructofuranosyl-α-D-glucopyranoside), nystose and f-nystose, respectively.

Stage I relaxation, as measured by percentage of the original stress relaxed, accounts for at least 50% of the total stress relaxed despite occurring in only 5 10 min and was attributed to lamella sliding and compaction, and permanent intralamellar crack closure (for tests conducted at higher temperatures).

The Sb/PAL composite with 9.7% Sb mass amounts showed outstanding catalytic performance by raising the p-nitrophenol conversion rate to 88.3% within 5 min, which was attributed to the synergistical effect of Sb and PAL nanoparticles facilitating the adsorption and catalytic hydrogenation of p-nitrophenol.

The removal of dye decreased from 100 to 61.6 % on increasing the initial dye concentration from 10 to 500 mg L−1 after 360 min; this was attributed to the increase of MB dye molecules adsorption onto the external surface of the organic kaolin composite, which increased significantly the local dye concentration, giving rise to the formation of aggregates of the dye on the composite particles.

The CFE from the Al-exposed cells also produced a major peak at 10 min that was attributed to oxalyl-CoA (Figure 5, Panel 2).