Sentence examples for min integration time from inspiring English sources
We present experimental results that demonstrate the performance of our sensor for measuring PM mass emitted from diesel exhaust and tobacco smoke, and show that it exhibits sensitivity approaching 2 μg/m3 with up to 10 min integration time.
When codon-optimized lux containing HEK293 cells were used in cell culture, concentrations of approximately 20,000 cells were reliably detected in 1 ml of media immediately using a 10 min integration time (Figure 2H).
To determine the minimum detectable cell number, HEK293 cells containing pLuxCDEfrp CO/pLuxAB at concentrations ranging from 1,000 to 500,000 cells were plated in triplicate in equal volumes of media over a constant surface area and imaged over a 10 min integration time.
Images were acquired using 30 min integration time.
The detection limits for acetaldehyde, acetone, isoprene, benzene, toluene, and p-xylene were determined to be at the sub-ppbv levels for a 1-min integration time.
These rain-rate data have 1-h integration time, so we used Chebil and Rahman's model [8, 9] for converting them to the equivalent 1-min integration time.
Error in derived temperature is inversely related to the photon counts and varies between less than 0.5 K at 40 km to 15 K at 70 km for a 60-min integration time and from less than 0.5 K at 40 km to 10 K at 70 km for a 120-min integration time for both the observing stations.
Due to scarcity of rain attenuation data in Nigeria, the measured point rainfall rates with 1-min integration time, range 0.001%≤%p≤1.0%[13]], were used for calculating the terrestrial attenuation over seven geographically spread locations.
The prototype instrument was tested at an indoor facility at the NRL with a 1.8-μCi and 13-μCi 252Cf neutron/γ source at three standoff distances of 9, 15 and 26 m (maximum allowed in the facility) over a 15-min integration time.
Immediately after the infusion, the light emitted by luciferase was measured, with a 1-min integration time.
The images were scanned using an Odyssey FC Imager (Dual-Mode Imaging System; 2-min integration time) and analyzed using Image Studio ver. 5.0 (LI-COR, Lincoln, NE).
