Sentence examples for min exposition of from inspiring English sources

Poly l-lactic acid) suPoly l-lacticc surfacid prepared by a phasuperhydrophobicthodology were treated with 30 min exposurfacesf UV/O3 irradiation using hollowed masks in order to obtain preparedd superhydrophilic squared-shaped areas.

The studies on the susceptibility of bacteria to the TiO2/UV process date back to 1985 when Matsunaga et al. [4] for the first time reported that a 120-min exposition of water polluted by E. coli and Lactobacillus acidophilus to the UV-A radiation resulted in an almost complete destruction of the bacteria.

Injury levels ranged from very low when only thymol or carvacrol was applied for short exposition times (around 20% of the population was injured after 5 min exposition to thymol, Figure 1(a)) to more than 99% of the population where more stringent conditions were applied (Table 2).

For these measurements, an operating temperature of 225 °C, a concentration of 200 ppm of CO gas, and a time of 10 min of exposition to this gas were used.

Both thymol and carvacrol inactivated about one log cycle of the initial population of L. monocytogenes cells within the first 20 min of exposition, showing δ values of 15.58 and 12.79 min, respectively, when these antimicrobials were added to the treatment medium (Table 1).

The test solutions were brought to test temperature and vented for a minimum of 15 min prior to exposition of the embryos.

Figure 6 STEM-HAADF micrograph of a base contact after a 150-min exposition under stress.

When both antimicrobials were added together, approximately additive results were reached, since one log cycle was inactivated within the first 10 min of exposition and a δ value of 8.74 min was obtained (Table 1 and Figure 1(b)).

Key results of the zirconia sampler tests with mercury halides were: the collection efficiency of >98%; reduction with 50 ppb ozone in the first 4 min of exposition to the atmospheric air ─ 6%±1%%; spontaneous reduction at 50 °C in the first 4 min after spiking ─ <0.6%.

The fire tests were stopped immediately after the exposed gypsum layer showed ablation, which happened shortly after 60 min of exposition.

Exposition of eosinophils with BAY 41-2272 for either 10 min or 90 min markedly inhibited the eosinophil chemotaxis, independently of IBMX pretreatment.