Sentence examples for min by increasing from inspiring English sources

Moreover, the heating time can be reduced to within 2 min by increasing cell output power using convective heating and mutual pulse heating.

Accordingly, at pH = 6.75 and contact time = 65 min, by increasing the initial concentration from 10.75 to 30.25 mg/L, removal efficiency of diazinon decreased from 92 to 85%.

While in the MR, the FAME yield increased from 23.2 to 90.1 % for a reaction time of only 20 min by increasing the ratio from 1 1 to 6 1, as seen in Fig.  4.

The glycemic target is 160 mg/dL from 2300 to 0200 h and then gradually decreases to 120 mg/dL by 0600 h, as shown in Fig. 2. If the current IOB is insufficient or less than the "insulin that should be on board," the system attempts to reduce the difference over the subsequent 30 min by increasing the basal rate up to a maximum of three times the usual basal rate.

The temperature program was 150°C for 2 min, followed by increasing the temperature by 20°C per min up to 280°C and holding it for 13 min. The injector was operated in the splitless mode and was kept at 280°C.

The experimental protocol consisted of an incremental exercise bout during which the subjects cycled with a cadence close to 80 revolutions per minute on an electrically-braked ergometer (Excalibur, Lode, Gröningen, The Netherlands), first at 100 watts (W) during 15 min, then by increasing workload by 40 W every 90 seconds (s) until the subject could not sustain the pedaling pace.

When PCR amplification was completed, HRM analysis was performed by lowering the temperature to 60°C for 5 min, followed by increasing the temperature ramping from 60°C to 95°C at 0.11°C/s, 25 acquisitions/°C.

The oven temperature was initially held at 120 °C for 3 min and raised to 180 °C by increasing 5 °C per min, then raised to 260 °C at the rate 5 °C per min, and finally held at 260 °C for 5 min.

The upper one, for the larger particles, is obtained by increasing κ min from 0.87 to 0.93.

The fired samples (0.17 g), without any pre-treatment, were flowed under O2 (5%% in He, 50 mL/min) by increasing linearly the temperature from 25 to 950 °C.

The field-emission scanning electron microscope (FE-SEM, S-4700, Hitachi, Ltd., Tokyo, Japan) images clearly reveal that the average height of the Si nanostructures increases from 96 ± 14 to 695 ± 47 nm and the etching rate of Si nanostructures increases from 12.8 to 92.7 nm/min by increasing the HNO3 concentration.