Sentence examples for min based on from inspiring English sources
Trace (d) is for the nanowires grown for 10 min based on the smaller catalyst fabricated.
D values found varied from 0.6 to 14.1 min based on the temperature, pressure and pH level combinations.
While settling, residual turbidity values were recorded at 3 30 min based on " Influence of TFC dosage variation". .
Oven toasting experiments were conducted with varying temperature (85.86 114.14 °C) and time (12.69 35.31 min) based on central composite rotatable design.
A first order kinetic model was achieved to describe the death rate in a time span of 60 min based on the capacitance.
We established a highly sensitive method for the direct quantification of the SA-β-Gal activity of individual multicellular spheroids within 6 min, based on scanning electrochemical microscopy (SECM).
On the last day of training, mean reaction time to the SD for the paired group was 0.243±0.042 min and the unpaired group was 0.296±0.047 min. Based on week three training data, we estimated the correlations of the SD, lever, and operant chamber with the self-administered cocaine infusion.
At the end of the tracer equilibration period, a primed-continuous insulin infusion (80 mU/m per min) was started, and plasma glucose was measured every 5 min. Based on the negative feedback principle, a variable infusion of 20% glucose was adjusted to maintain plasma glucose concentration constant at each subject's fasting glucose level in the control group (18).
The cycling conditions were an initial denaturation at 95°C for 5 min, template denaturation at 95°C for 50 s, annealing at 55°C for 1.5 min, and extension at 72°C for 2 min for a total of 30 cycles, with a final extension at 72°C for 7 min. Based on the results of individual priming, an mPCR was designed.
The equilibrium time for Ni II) adsorption on the pigeon pea pod is obtained at 45 min. Based on the Langmuir isotherm, the maximum adsorption capacity was calculated to be 19.23 mg g−1 of adsorbent.
(c) AFM image of the scratched area after etching in 20 wt.% KOH + IPA solution for 25 min. Based on the friction-induced selective etching method, a series of nanopatterns were fabricated on the Si(100) surface, as shown in Figure 7.
