Sentence examples for min at high from inspiring English sources

Volumes (0.11) of 10× cytoplasmic extraction buffer (0.3 M HEPES, 1.4 M KCl, and 30 mM MgCl2) was added to the supernatant and sonicated for 30 s ON/OFF for 5 min at high power in Bioruptor (Diagenode).

A 20 mL aliquot 1 mol/L HCl was added and the mixture stirred during 20 min at high speed on magnetic stirrer.

This experiment included three treatments: (1) 200 g of the mushroom was ground in a blender (MJ-M176P, Panasonic Limited, Malaysia) for 3 min at high speed with 400 mL water.

Survey spectra were acquired with an accumulation time at least of 20 min at high pass energy (187 keV) while high-resolution spectra of the elements of interests where acquired at 11.7 keV with same power and 0.1 eV resolution.

After that we added stone seeds, unsaturated resin and filler (7 wt% micro-Si or calcium carbonate for minimize pores) to mixture of water and cement and then mixed for 1.5 min at high rpm.

A pressure of 5kN (100 MPa) was applied to the sample from the beginning of the heating time and up to 800 °C (highest temperature tested, which was reached in 8 min, and a constant dwell time of 6 min at high temperature).

The laccase was very stable at pH 4.5 and at 40 °C but half-lives decreased to 120 and 125 min at higher temperature (60 °C) and lower pH (pH 3).

The maximum time of lag phase was found to be 290 min at lower flow rate of 1 ml/min and 190 min at higher flow rate 90 ml/min when using 40 g/l of glucose.

The maximum time on lag phase was found to be 190 min at lower flow rate of 4 ml/min and 90 min at higher flow rate 90 ml/min when using 10 g/l of glucose in medium with 4 mm size of beads (Figs. 2, 3).

To allow for maximal rod recovery between consecutive flashes, inter-stimuli-intervals was increased (as the stimulus intensities were progressively increased) from 10 s at lowest stimulus intensity up to 2 min at highest stimulus intensity.

For example, pollinator visitation rates to Chaetanthera euphrasiones capitula ranged from zero at low elevation (2810 m) to 0.12 visits per capitulum per 25 min at higher elevation (3315 m).