Sentence examples for milling were studied from inspiring English sources

Effects of process control agents, material load and material to water ratio during attritor milling were studied.

The deformation structures of copper powder induced by ball milling were studied in detail by using high resolution electron microscopy.

The initiation and progress of the coating and tool wear in milling were studied using scanning electron microscopy and energy dispersive X-ray spectroscopy.

The groove difference (i.e., dimensional accuracy of groove width) and the roughness average at the bottom plane of the inside groove (i.e., the plane of end milling) were studied.

The changes in pore structure, morphology and acid/basic properties caused by ball milling were studied by means of N2 adsorption/desorption, Fourier-transformed infrared spectrometry, Boehm's titration and Scanning Electron Microscopy.

The phase evolutions, particle size distribution, and morphology of particles during milling are studied during a 40-h grinding period.

Very fine Si NCs with few nanometer sizes obtained after every 2, 5, 10, 20, 30, and 40 h of ball-milling were studied.

As a consequence, these two severe respiratory infections suffered by employees working in proximity of waste water treatment plants of two different paper and pulp mills were studied in more detail for suspected Legionella infection.

On the other hand, the surface generation mechanism in peripheral milling with variable pitch end mills is studied.

Numerous models of the SAG mill are studied in the literature, but the majority of them do not evaluate the predicted model for full-scale mill performance.

The release of xylose reductase (XR) from Candida mogii by cell disruption in a glass beads mill was studied using an experimental design.