Sentence examples for milling surfaces are from inspiring English sources

The contact conditions of using lathe turning surfaces and end-face milling surfaces are simulated.

Based on the Fourier transforms, the models of the surface topographies of both lathe turning surfaces and end-face milling surfaces are proposed.

In this paper, the characteristics of squamous surface and ultrasonic vibration assisted milling surface are analyzed and discussed.

Ultrasonic vibration assisted milling surface is formed by tool tip path and influenced by vibration frequency and amplitude, cutting tool diameter, feed speed, spindle speed, spindle rotation accuracy, etc.

In this paper, the largest milling surface was 30 μm wide whereas the ultrathin sections were approximately 1 mm wide.

In areas with extensive protruding CNTs, a smooth milling surface was sought obtained by slow deposition of a thick platinum layer (about 1.5 μm) with the gaseous injection system and the ion beam.

The surface roughness of a milled surface is an important response parameter in finishing milling.

The existing asphalt concrete (AC) surface was milled to an average depth of 102 114 mm (4 4.5 in) and the milled surface was then overlaid with a uniform 25 mm (1 in) of AC.

In this paper, optimum positioning of the conical cutter for five-axis flank milling of slender surfaces is addressed from the perspective of approximating the tool envelope surface to the data points on the design surface following the minimum zone criterion recommended by ANSI and ISO standards for tolerance evaluation.

Both the thick platinum layer and the alternate milling strategy where the milling surface could be polished prior to slice-and-view imaging decreased the milling artefacts, but artefacts originating from the block caused by differing milling yields remained (highlighted by arrowheads in Fig.  5e and Fig.  S6, Electronic Supplementary Material).

Despite the difference in process mechanisms, fatigue results for the milled and wire electrical discharge machined surfaces were comparable.