Sentence examples for mill configuration from inspiring English sources

The chapter describes SAG mill configuration and operation, ball-mill circuit operation, gold recovery in comminution circuits, alternate grinding technologies, and ore sorting in detail.

To explore the impact of ion milling on the maturity of shale samples as measured by vitrinite and solid bitumen reflectance, five different ion milling configurations were applied to a set of organic-rich New Albany Shale (Late Devonian-Early Mississippian) samples that range in maturity from immature to post-mature.

Specifically, for the two least mature samples, the most aggressive milling method (configuration D) increased reflectance of vitrinite from 0.48% to 0.58%, and from 0.58% to 0.74%.

It uses a so-called Mills Cross array configuration, installed underneath a survey ship, transmitting a beam wide perpendicular to the ship's moving direction (across-track) and narrow parallel to the ship's moving direction (along-track) and forming multiple receiving beams narrow across-track and relatively wide along-track[1].

Different steam consumptions in the process are considered, in order to better integrate these configurations in the mill.

For comparison reason, various captive power plant configurations of integrated steel mill without carbon capture were also considered.

This is mainly due to the fact that it is the type of paper mills (packaging, recycling, kraft) and the water system configuration that determine the COD, toxicity and organic load of the effluent.

The performance of ball end mill cutters in cutting operations is influenced by the configuration of the rake and clearance faces in the ball component.

Therefore the goal of this paper is to propose and apply a simplified stirred mill model that will then be used to assess configurations in the stirred mill design space.

The optimal design configurations are determined through studying the material to be milled in a laboratory mill under standard conditions.

The presented thermal test piece is machined during a corresponding eight hour test cycle and tested on two 5-axis milling machines with different axis configurations.