Sentence examples for mild roughness from inspiring English sources
The following definitions were used to describe palatal rugae: tenous palatal rugae, where a mild roughness, corresponding to pressure exerted by the tongue in resting position, was observed; pronounced palatal rugae, where hypertrophic rugae due to lack of stimulation by the tongue during resting position or swallowing were observed [ 13].
This sample exhibits lowest contact angle, low relative roughness, and only mild increase of electrical conductivity.
No clear trend correlating the absorptance with the roughness was found for mild steel in the roughness range Sa 0.4 5.6 μm.
The corrosion of mild steel in acid media increases the roughness of the electrode surface and, therefore, reduces the phase angle [15].
This paper presents a study of the development of a surface roughness model for turning of mild steel with coated carbide tools.
Maximum number of cells is observed on the sample sputtered for 20s at 40 mA, exhibiting lowest contact angle (see Figure 3), low surface roughness (see Table 1), and mild increase in electrical conductivity (see Figure 2).
The purpose of this work is to investigate the influence of electropolishing process on performance parameters of nickel coating electroplating on Q235A mild steel as substrate, including the surface roughness, thickness, elastic modulus and hardness.
35 Kligman and Kligman used SA as a superficial peeling agent in 50 women with mild to moderate photodamage, and reported improvement in surface roughness and pigmented lesions, along with a reduction in fine lines.
The substrate of mild steel is characterized by an even surface (Fig. 7a, b) with roughness R a = 0.007 and R q = 0.010.
EXTRA POINTS Safety Antrel Rolle was fined $7,500 for unnecessary roughness for a hit on Ravens wide receiver Mark Clayton, who sustained a mild concussion, in the Giants' 24-10 loss in Baltimore last Saturday.
The effect of electrode surface roughness on the kinetics of the hydrogen evolution reaction has been studied for mild steel and nickel cathodes in 10 M NaOH at 348°K.
