Throughout the present study, the identification of turns was based on the trajectory of the midpoint (point located on the skeleton at a third of the distance from the head).
In this example, you want to find the midpoint, point O, which is between the two endpoints M (5,4) and N (3,-4).
The means of the scores on attitude (ranging from 2.75 to 3.36) and the means of the scores on the QOCS (ranging from 2.95 to 3.28) were around the midpoint, pointing towards neutral attitude towards disability and a moderate but unfavorable level of care quality.
This is because 20 of the Screen 2 conditions are identical with the best conditions from Screen 1 and are used as the midpoint controls (centre points).
The coded values set for glucose (A) and sucrose (B) at three levels were −1 (0:1), 0 (0.75:1) and 1 (1.5:1), resulting in four factorial points (consisting of all possible combinations of the maximum and minimum levels), four axial points (one of the factors set at the midpoint) and five centre points (replicated experimental runs at the factors midpoint), all shown in Table 1.
The selected FFPs and the three facial lines are shown in Figure 4c, where the facial center line is on the center point of the bottom of nose while the facial right and left boundaries are obtained from the midpoint between the two points located on each side of the facial contour, respectively.
This cubic design is given by a set of points at the midpoint of each edge of multidimensional cube and a center point replicate (Palamakula et al. 2004).
Facial feature annotation points delineate the supra-orbital ridge (8 points), the eyes (mid points of the eyelids and eye canthi, 8 points), nose (nasion, tip, ala, subnasale and outer nares, 7 points), mouth (vermilion border lateral and vertical midpoints, 6 points) and the jaw (zygoma mandibular border, gonion, mental protrubance and chin midpoint, 7 points).
The midpoint between points P1 and P2 was determined and considered to be the midpoint of the isthmus tube.
Waist circumference is measured at the midpoint between highest point of iliac crest and lowest point of costal margin using a Gulik tape measure; two measures of waist circumference are taken; if the difference exceeds 1.0 cm, a third measure is taken.
The bridge is modelled as a simply supported beam and deflections at the quarter point, midpoint and three quarter point are used as the inputs to the MFI algorithm.
