Sentence examples for mid position of from inspiring English sources

The culm is complimented by the branching system which is more informative at mid position of the culm than the lower culm body (Das et al. 2008).

However, in the whole process of gripper manipulation, the CM projection of 5-TET on the ground was always in the support area, and the majority of CM projections were in the mid position of the support area, which maintain it stable during gripper manipulations.

Lateral subsurface flow discharged out from the 30 80 cm soil layer at the mid positions of the two hillslopes and the lower position of CVS; while the lateral subsurface flow from the upper hillslope recharged into the 30 80 cm soil layer at the upper and lower positions of the CCS and the upper position of CVS.

In the EBR samples, a power function was able to describe a mid positioning of the experimental bond stresses (i.e. the corresponding mid-range values between the maximum and the minimum experimental bond stresses) obtained along the slips within the interface at the SS loaded end.

We therefore used the estimated mid positions of the mapped reads as observed features and the radial basis function (RBF) as kernel k x, x′) = exp[- x -  x′)/(2 σ)].

The oral position of the canulla was adjusted to place the ports in the midline at the mid-position of the open mouth.

The mass center (Figure 3) of a cluster can be defined as the mid-position of the sensor distribution within the cluster.

The center of each peak was set to the mid-position of the six highest consecutive probe values.

The angular and spatial trajectories were then fitted with the following model: x = A · | t | n K n + | t | n + c t e, where x is the mid-position of the spindle poles or the angle they make with respect to the A-P axis.

Before the match Maribor was leading the table and was close in winning their eighth consecutive title while the mid table position of Mura was predetermined before the final round.

The metrics of the waveforms, such as the noise floor, peak magnitude, mid-point position of the leading edge, leading edge slope and trailing edge slope, can be derived from the parameters of the proposed models.