Sentence examples for mid frequency of from inspiring English sources

The authors in [26] suggested that the heavy tailed property for low and mid frequency of DCT coefficients can be modeled by the zero mean generalized Gaussian distribution (GGD) [26] as f X ( x ) = α e - β x c, (6).

The intima plus medial thickness of the right common carotid artery was determined using a high-resolution B-mode ultrasonographic system (Logic 400 GE, Milwaukee, Wisconsin) with an electrical linear transducer mid frequency of 7.5 MHz.

A series of ultrasonographic scans was performed using an echotomographic system (NEMIO SSA-550A, Toshiba Medical System Corporation, Tokyo) with an electrical linear transducer (mid frequency of 7.5 MHz).

Due to its lower spectral energy boundary and its high acoustic-energy concentration at mid frequencies of about 3 4 kHz, creates an inherently "dark" aperiodic pitch impression.

Then, linear relation is fitted to five-point sliding segments with 30%% overlapping of the new series and the obtained slope values are recorded in terms of the mid frequencies of the segments.

The BAM neural network supports creation of weight matrix (formed out of multiple images) and this matrix is embedded into the DWT uncorrelated mid frequency coefficients of all the components (Y, Cb, Cr) of every frames of the video with varying embedding strength 'α'.

High frequency hearing loss may be detected in early childhood, and typically progresses to reach moderate to mid frequency levels of 40 60 decibels (dB) at about 50 years of age, and can exceed 80 dB at 1 kHz in later years, causing significant problems with speech discrimination in affected patients.

After scrambling the binary watermark, a block-based DCT transform of the first-level DWT LL sub-band is computed and two PN-sequences of the watermark bits are embedded in the mid frequency coefficients of the corresponding DCT blocks.

Based on the damping analysis in the wave domain, the thresholds of mid frequency and high frequency vibration characteristics of the composite plate are illustrated.

Two ventilation noises were used, one of a predominantly mid frequency character and the other of a predominantly low frequency character.

This paper presents a simulation study concerning the low and mid frequencies control of flexural vibration in a lightly damped thin plate equipped with five time-varying shunted piezoelectric patch absorbers.