Sentence examples for microscopy pore size from inspiring English sources

After silica removal, X-ray scattering, transmission electron microscopy, pore size analysis and Raman spectroscopy showed that the resulting material was a negative replica of the silica template with a 2D-hexagonal P6mm ordered structure, possessing a large surface area (724 m2 g−1), a monomodal pore size distribution (3.4 nm) and a relative hydrophobic surface with graphitic pore walls.

Scanning electron microscopy and pore size distributions for the composites made from commercial silica gel and from sol gel chemistry are also reported and compared.

The support and the catalysts were characterized by XRD, Transmission electron microscopy (TEM) pore size distribution measurements.

The porous topography was investigated by scanning electron microscopy and the pore size was controlled by fabrication conditions such as the concentration of porogen.

The micro structural characterization was examined before and after exposure to high temperature by scanning electron microscopy and the pore size distribution was obtained by mercury intrusion porosimetry.

Morphological evaluation of these films using Scanning Electron Microscopy (SEM) showed smaller pore size than the control.

The porous structure of the scaffold was observed by scanning electron microscopy (SEM), and the pore size was controlled by fabrication conditions including swelling time and composition of the HA matrix.

The microstructure of the hardened cement pastes and their morphological characteristics were examined by scanning electron microscopy, whereas porosity and pore size distribution were evaluated by mercury intrusion porosimetry.

The field emission scanning electron microscopy, nitrogen adsorption desorption and pore size distribution analysis reveal that the introduction of a small amount of carbon nanotubes (CNTs) can effectively increase the surface roughness and porosity of polyvinylidene fluoride (PVDF).

Information on either the mass distribution in S-layer lattices obtained by high-resolution electron microscopy or the 'functional pore' size derived from permeability studies led to the use of isoporous protein lattices for the production of ultrafiltration membranes with very accurate molecular weight cutoffs (Sleytr & Sára, 1986; Sára & Sleytr, 1987b, c; Sára et al., 1988b).

The calcined samples were characterized by X-ray diffraction, UV-DRS, atomic absorption spectroscopy (AAS), temperature-programmed reduction (TPR), temperature-programmed desorption (TPD-NH3), scanning electron microscopy (SEM), transmission electron microscopy (TEM), surface area and pore size distribution measurements.