This was achieved using standard methods as suggested by Rodier (1996).
The current state-of-practice static pushover methods as suggested in the provisions of European and American regulations are implemented in this comparative study.
Subsequently, the samples were analyzed in the laboratory for their chemical constituents such as Ca2+, Mg2+, Na+, K+, Cl−, SO42−, HCO3− and NO3−, using standard methods as suggested by the American Public Health Association (APHA 1989, 1995a, 1995b).
The collected water samples were analyzed in the laboratory for cations (Ca2+, Mg2+, Na+ and K+) and anions (HCO3 −, CO3 2−, SO4 2−, Cl− and NO3 −) using the standard methods as suggested by the American Public Health Association (APHA 2005).
Water samples were analyzed at the laboratory for chemical constituents, such as calcium, magnesium, chloride, bicarbonate, sodium, potassium, and sulfate by employing standard methods as suggested by the American public health association (APHA 1989).
The obtained social network visualizations (key part of our data analysis) added rigor and comparative logic to the qualitative description (via triangulation of research methods) as suggested by Eisenhardt [93, 138].
In our study, we used an active sampling method, as suggested in the ISPESL guidelines [11].
The inverse slope vertical electrical resistivity (VES) method as suggested by these two authors works very well in engineering geology and also in groundwater exploration for 2 5 layered.
Selection of the two "parents" chromosomes: from the population X t of chromosomes available at iteration t, the parents chromosomes are selected with the roulette wheel method, as suggested in Zheng and Zhang [18].
Damage Locating Vector (DLV) method as suggested by Bernal in 2002[1] has received significant attention because this method was verified by a series of proof-of-concept tests measuring accelerations.
Beam column analysis of the top chords in the failure region was performed using both the conventional interaction design equations and the direct strength method as suggested in CSA S136-07.
