Sentence examples for method the reaction from inspiring English sources

In biphasic solvothermal reaction method, the reaction occurs at the interface of water phase and organic phase at elevated temperature.

Thus, by using the new method, the reaction coefficient of a reaction process can be accurately determined even if it is not reaction-limited.

For the neutral-acid extraction method, the reaction liquid was directly extracted with an organic extractant, then the pH was adjusted to 2, and the reaction liquid was extracted again.

In this method, the reaction initiates at a slower rate, thereby slowing development of the elastic modulus, giving the material an opportunity to accommodate the dimensional change of viscosity, and leading to a reduction in the shrinkage stress at the adhesive interface [19].

It is important to note that the reaction in the presence of Fe3O4 or ZnO-NPs needs larger amounts of catalysts at high temperatures (Table 5, entries 8 10), while in the present method the reaction is carried out under very mild conditions using few amounts of W-doped Znanocompositeite.

We conclude that 1) the hybrid of HAuCl4 and DDT can form nanotubes through self-assembly method; the reaction equation is Au3+ +3RH → Au(I -SR + RS-SR +3H+[19], but thI -SRocess requires a longer time (stirring for at least 20 h).

In iterative methods, the reaction sites are regenerated after each iterative reaction sequence, and the same reactions may be repeated to afford successively and, in principle unlimitedly, the objective polymers until a steric limitation is encountered.

With the three methods, the reaction appears to go to completion (Fig. 2A) which shows that the overall forward reaction of APH(3′ -IIIa is virtually irreversible.

After AE21 had been reacted with E275C (Materials and Methods), the reaction mixture was analyzed using SDS PAGE followed by Western blotting.

For continuous-flow methods, the reaction time at which the analysis occurs is determined by both the flow rate of the reactants and the volume between the mixer and the detector.

We would recommend that during the lysis step described in the methods the reaction mixture should be incubated at 37°C as the SDS/NaOH solution precipitates at room temperature.