Sentence examples for methanol were found from inspiring English sources
After Pt/MWCNTs composites were fabricated, the different properties of cyclic voltammetry and chronoamperometry in electro-oxidation of methanol were found.
Acetates, THF and ketones were found to be good solvents for PIBORNMA, whereas alkanes, aromatics and methanol were found to be non-solvents.
Twenty five GB-ILs (tetramethylammonium, tetraethylammonium, tetrabutylammonium, 1-ethyl-3-methy limidazolium, and choline salts of Tricine, TES, MES, HEPES, and CHES) were tested as organic-phase buffers for pure methanol, and their buffer capacities in methanol were found to be very close to that in water.
In both the chronoamperometric and chronocoulometric studies, the reaction of methanol electrooxidation followed a Cottrellian behavior and similar diffusion coefficients (D) of methanol were found to be 3.82 × 10−7 cm2 s−1 and 3.91 × 10−7 cm2 s−1, respectively.
Reaction order with respect to methanol was found to be 0.5.
Under open circuit conditions, methanol was found to adsorb preferentially onto the Pt sites associated with "strongly bound" hydrogen.
Within the experimental range, the volume of methanol was found to be the most important factor, having a positive influence on the FAME yield.
Using an active catalyst, the rate of steam reforming of methanol was found to be significantly faster than that without a membrane module.
After 24 h visible light illumination, the yield of methanol was found to be 1644 and 1294 μmol g−1 cat for GO-Cs2Mo6Bri8Brax and GO- TBA)2Mo6Bri8Brax, respectively.
Under the CA regime the reaction followed a Cottrellian behavior and the diffusion coefficient of methanol was found to be 4 × 10−6 cm2 s−10−6
In order to make triclosan soluble methanol was found to be a good solvent but had other problems like increase in cost and possibilities of interfering with other finishes.
