Sentence examples for methanol for a from inspiring English sources
The Faradic conversion efficiency can be as high as 94.8%, and the energy conversion efficiency can be as high as 23.9% if the environmental temperature is low enough (10 °C) under constant voltage discharge at 0.6 V with 3 M methanol for a DMFC bi-cell.
As an illustration of the effect of rainfall and evapotranspiration on various transport mechanisms, test cases are presented for the transport and volatilization of benzene, 1,1,2,2-tetrachloroethane and methanol for a loam-type soil using self-consistent dynamic rainfall and evapotranspiration weather sequences.
Leaves and flowers of H. foetidum and leaves of H. mechowianum were extracted exhaustively with 90%% methanol for a period of 72 h.
Centrifugation followed by removal of aqueous solution resulted in the sulfonated graphene, which was rinsed with methanol for a few times then dried at 80°C under the N2 atmosphere.
Smears were fixed in methanol for a few seconds and then stained for 10 min with Giemsa (Merck Chemicals, Darmstadt, Germany) diluted 1 10 in Sorenson's buffer, pH 7.2.
Open image in new window Fig. 4 ANN modeling and experimental comparison effects of methanol for a propane conversion, b propylene selectivity and c propylene yield on PDH over industrial Pt Sn/γ-Al2O3 catalyst in oPt Sn/γ-Al2O3 of methanol addition at 575 °catalyst
Working solution was prepared freshly before each assay by diluting the stock solution by mixing of stock solution to 50% methanol for an initial absorbance of about 0.700 (± 0.02) at 745 nm, with temperature control set at 30°C.
Unscrupulous vendors frequently spike the spirit with methanol for an extra kick, and there are rumors that jet fuel and embalming fluid are sometimes added to the mix.
The gel was then fixed with acetic acid and methanol for an hour.
Before being used in the assay, the ABTS radical cation was diluted with 50% methanol for an initial absorbance of about 0.70 (±0.02) at 745 nm, with the temperature control fixed as 30°C.
Culture samples (1 mL) were taken directly from culture vessels at the indicated times, centrifuged for 2 min at 13,000 rpm, and the pellets were resuspended in methanol for chlorophyll (a + b) extraction [ 58].
