Sentence examples for mesh fraction from inspiring English sources

The 325 mesh fraction was transferred onto a Baermann tray (Whitehead and Hemming 1965) and incubated at room temperature for 24 h.

Traditionally, the collected samples are sent to the National Air and Dust Laboratory for moisture and low temperature ash analysis to determine the percent of incombustible content of the minus 20 mesh fraction.

Current processing trends tend to increase the top particle size reporting to the fine circuit to be about 10 mesh to reduce the load on the intermediate size circuits or to allow processing of the entire +10 mesh fraction using a single processing unit operation.

Particles larger than 20 mesh were reground and sieved again, and the resulting 20 to 80 mesh fraction was mixed with the 20 to 80 fraction obtained originally.

Unpretreated switchgrass (Alamo, sieved 20/80 mesh fraction, grown in Athens, GA, harvested April 2011) was obtained from Dr. Ajaya Kumar Biswal and Dr. Debra Mohnen, University of Georgia, GA.

The -20/+40 and -40/+60 mesh fractions of the unsorted MPS were used in the optimization, which was performed at five different hydrothermal pretreatment times, all at a temperature of 180°C.

The high average AcIR content for LP leaf was mainly associated with two particle-size fractions of this component, the -20/+40 and -40/+60 mesh fractions, which exhibited AcIR contents of 72%and48%8%, respectively, compared with values of 17%to35%5% for all the other particle-size fractions tested in this study.

The DIC results show that as the mesh volume fraction increases, the flexural capacity (about 14 70%), ductility index (about 9 24%), energy absorption (about 16 107%) and number of cracks increase but the length and width of cracks decrease.

The test variables were the wire mesh volume fraction: four expanded and two square types; slab thickness: 40, 45, 50 and 60 mm; and the patch load pattern: square and rectangular.

The 100-mesh passing fraction, 81% of which was smaller than 40 μm, was used for this preparation as activated carbon particles.

The total lipid extract was separated chromatographically on a glass column using 3 g of silica gel (60 mesh) into three fractions: a non-polar fraction (dichloromethane), a glycolipid fraction (acetone), and a phospholipid fraction (methanol).