Sentence examples for membrane seal from inspiring English sources
A small depolarization (∼8 mV) in the resting potential of the patch clamp was observed as the nanowire probe entered the cell, which is probably because of leakage of the patch electrode membrane seal and not nanoFET leakage, as follows.
Third, extended recording with a nanoFET probe (Supplementary Fig. 2) yields full-amplitude 85 mV AP signals over a five minute period with <3% loss of signal amplitude, and thus demonstrates a high-quality membrane seal and minimal effect on the physiological status of the cell by nanoFET insertion.
Whole cell current recordings were accepted during those experiments only if membrane seal resistance was ≥1GΩ, maximum current amplitudes were ≥400 pA, and minimal cell capacitance was displayed after compensation.
Fiber-filled borosilicate patch pipettes were prepared to give tip and membrane seal resistances of 5 10 MΩ and 10 15 GΩ, respectively (8).
In three patches where it was possible to maintain a high-resistance membrane seal, the inhibitory effect of SOM was reversed by washout.
We transfected chondrocytes with hTERT or GRP78 and cultured them in a 3-dimensional atelocollagen honeycomb-shaped scaffold with a membrane seal.
Finally, the crescent-shaped tubular membrane seals to form a double-membraned autophagosome with cytoplasmic components enclosed within the inner membrane.
A porous polymeric membrane sealed at the bottom of each well accounts for the sensor support.
The spheres are attracted to the negatively charged surfaces of the nanowires, where they accumulate and fuse together to form a continuous membrane that completely seals each nanowire just as a biological membrane seals the contents of a cell.
A catalytic membrane reactor containing a tubular palladium silver (PdAg) membrane sealed in the centre to separate in situ the hydrogen produced, was used to exceed equilibrium limitations in the dehydrogenation of methylcyclohexane.
After filled the all soil into the specimen tube, the cylindrical surface of the sample is covered by the rubber membrane sealed by rubber O-rings on the top and base of load system.
