Sentence examples for melt region from inspiring English sources

rapid cooling of the melt region has resulted in hard Widmantatten structure responsible for the improvement in slurry wear erosion.

The run charges generally showed a zonal structure composed of two contrasting regions: a central region within which the bubbles were concentrated (bubble-rich core, BC) and a bubble-free melt region surrounding the BC (bubble-free margin, BFM).

In the simulation, mold heat transfer is considered as cyclic-steady, three-dimensional conduction; heat transfer within the glass melt region is treated as transient, one-dimensional conduction; heat exchange between the cooling system surface and coolant is treated as steady, as is heat exchange with the ambient air and mold exterior surface.

Key analysis functions, such as to obtain the first derivative curve using Savitzky Golay filter, to identify the melt region, subtraction of background fluorescence and curve normalization, are introduced, followed by case studies of HRM analysis using the developed software program.

Davison et al. (1996) and O'Dowd et al. (1997) showed that the rate of new particle formation is strengthened by higher emissions of dimethyl sulphide in the ice melt region around the continent of Antarctica.

Therefore, we have defined a relative scattering length density of the melt region compared to that of the core.

Depending on buoyancy and rheology the plume self-adjusts its radius well before reaching the melting region.

However, the microstructure of the coating with a composition of 50%Al-20Al-20as more compact, and it was morely compactd of equiandd crystal it the partially melted region and net-like structure in the fully melted region, wasle the partially mainly region was embedded in the fully melted region.

The nanostructured coatings consisted of completely melted region of γ-Al2O3 phase and partly melted region, and the fraction of the partially melted regions and pores decreased with increasing CPSP.

The results show that the ceramic coating consists of both fully melted regions and partially melted regions, and the fully melted region has a lamellar-like structure as the conventional coating.

No melting, partial melting and excessive melting region at different offset ratios are determined.