"meet the accuracy" is not a grammatically correct phrase.
A better way to phrase it would be "achieve accuracy" or "meet the required level of accuracy." For example: - The scientist conducted multiple experiments to achieve accuracy in her results. - The company worked hard to meet the required levels of accuracy in their financial reports. - In order to meet the accuracy standards, the students had to carefully measure each ingredient for the science experiment.
In addition, it is almost appropriate to meet the accuracy constraints of many applications.
Iteration should be stopped if the optimized camera parameters meet the accuracy requirements.
Note that, the orders of Taylor series expansion can be adjusted to meet the accuracy of satisfactory imaging results.
In Table 2, the approximation of exponential function can meet the accuracy only for very small error.
Comparative assessment with conventional approach confirms that this algorithm can meet the accuracy standards of the industrial relays due to better reliability.
The low signal-to-noise ratio of the images leads to a large amount of low-level tasks in order to meet the accuracy requirements.
As an introduction of shadowing for first timers, in order to develop a solid foundation of the shadowing technique, monologic script in a steadily paced model audio is considered ideal to meet the accuracy-based objective.
Simulation results indicate that the multi-scale modelling approach followed, meets the accuracy needs for capturing the cracking process of the welded joint with high computational efficiency.
By using the method proposed in this paper, the measuring system can achieve a measurement accuracy of approximately 1 mm, which meets the accuracy requirement of large radar antenna automatic assembly application.
It can be seen from the table that the relative errors of angle results are all less than 11%, which means that the mode shape angle can be identified accurately from ambient data; the relative errors of magnitude results are a little bigger, yet still less than 15%, which also meets the accuracy requirements of engineering.
Finally, a parameters design experiment and a cutting experiment of an S-shaped test piece are performed, the results show that compared with the original control parameters used in industry, the tracking error of the driving shaft is much better when using the optimized control parameters, and the test piece meets the accuracy requirement.
